IMS IM483I

€34.95
Tax included

IMS IM483I Performance Microstepping Stepper Motor Driver with Indexer

Condition
Quantity
In Stock

PayPal
15 Items

IMS IM483I High Performance Microstepping Driver with Indexer

Tested - some rust on the black heatsinks visible

Incorporated into the IM483I & IE drivers are proprietary circuits that minimize ripple current while maintaining a 20 kHz chopping rate. This prevents additional motor heating that is common with drivers requiring higher chopping rates. Now low inductance stepper motors can be used to improve high speed performance and system efficiency.

The built-in indexer on the IM483I & IE allows the user, via a serial link, to pro gram parameters such as acceleration/deceleration ramps, velocity, position, resolution and drive current to form simple or complex motions.

Programs can be executed by sending single commands, or can be stored in the on-board nonvolatile memory which can then be executed on power-up or by discrete user inputs.

Electrical Specifications

Input Voltage* : +12 to +48 Volts

Drive Current Per Phase – Software Selectable : 0.4 to 4 Amps Peak (Max 3 Amps RMS)

Isolated Logic Inputs : Limit A, Limit B, Home, Party

Baud Rate : 9600

Velocity Generator Range : 20 to 20,000 steps/second

Motor Resolutions – 1.8°/Full Step : Auto-Variable, 200, 400, 800, 1600, 3200, 6400, 12800, 25600, 51200

Position Counter : ± 8,388,607.99

Nonvolatile Memory : 2k Bytes

Inputs – General Purpose : 3 (0 to +5 VDC)

Inputs – Dedicated [Go, Jog +, Jog –, Jog Speed, Soft Stop] : 5 (0 to +15 VDC)

Outputs – General Purpose : 3 (0 to +5 VDC)

Encoder Resolution : 50 – 2000 (Lines in 50 line increments)

Protection : Thermal and All Way Short Circuit

IM483I
15 Items

Specific References

You might also like